PatternMaker
gloriadeb — 2020-04-12T17:45:33-04:00 — #1
I just installed PM on a new computer.
I can't seem to configure the icon bar.
I went into Configure and Configure defaults. There isn't anything there to give me a way to add icons.
Also, my Draw dropdown only has one choice - Offset - and it's grayed out.
stofftante — 2020-04-13T05:42:34-04:00 — #2
Gloria, if that is the case your PM is not registerated. When you load it to a new computer you must fill in the serial number you had in your old computer to have again access. You get 2 registrations when you start. If you have used them, ask the support and explain it. They will help you.
lgheidi
gloriadeb — 2020-04-13T06:00:15-04:00 — #3
When I choose Register in the dropdown menu, the info including the registration number is there.
A message pops up that says "No registrations left".
Is this because I have the program on 3 computers - one of which is no longer operable? I can't delete the program there.
What can I do?
gloriadeb — 2020-04-13T06:09:15-04:00 — #4